Square expansion bellows serve clinker cooler exhaust and coal mill ducting in cement plants, where dust-laden gas at moderate-to-high temperature demands internal abrasion liners alongside the standard square-duct reinforcement considerations that apply at any duct size and pressure.
Two more duct locations in the cement production line
Beyond the kiln inlet, preheater, and raw mill ducting covered in the broader cement industry content on this blog, two further locations commonly use square expansion bellows: the clinker cooler’s exhaust ducting and the coal mill system that prepares pulverized fuel for the kiln burner.
Clinker cooler exhaust ducting
As hot clinker moves through the cooler, it’s cooled by forced air that picks up heat and dust before exiting through exhaust ducting — often connecting downstream to dust collection or ESP equipment. This ducting runs at lower temperature than the kiln itself but still carries meaningful dust loading, making an internal liner a sensible standard feature even though the thermal severity is less extreme than kiln inlet ducting.
Coal mill ducting
Coal mill systems grind and dry coal using hot gas, often drawn from the kiln system, to prepare pulverized fuel for the kiln burner. This ducting combines moderate-to-high temperature with fine coal dust — a combination that calls for careful liner and material selection given both the abrasion risk and, in some mill configurations, specific safety considerations around combustible dust that should be addressed in the mill system’s overall design, separate from the expansion bellows itself.
What to specify
Duct dimensions and aspect ratio, gas temperature specific to the cooler or coal mill location, dust loading and particle characteristics, and confirmation of internal liner requirements — treated separately from kiln inlet or preheater ducting given the different temperature and dust profile at each location.
Generally no — cooler exhaust runs at lower temperature since the air has already picked up heat from cooling the clinker rather than coming directly from the combustion zone, though dust loading remains a real consideration at this location.
Coal dust handling systems often have specific combustible dust safety requirements that should be addressed in the mill system’s overall design; the expansion bellows itself should be specified to fit within that broader safety design rather than in isolation.
Not automatically — the two locations have different temperature and dust characteristics, so each should be specified against its own actual operating conditions rather than assumed identical.